Replacing The Battery - Dell Z9000 Manual

Z9000 system

Hide thumbs Also See for Z9000:

Table of Contents

Remove the card.

Figure 14. Illustration of removing the SD Card

Replacing the Battery

The lithium battery is not field replaceable.

Only authorized personal should remove and replace the battery. If the battery requires replacement,

contact Dell Networking Technical Support.

WARNING: ESD damage can occur if components are mishandled. Always wear an ESD-

preventive wrist or heel ground strap when handling the S4810–ON and its components. As with

all electrical devices of this type, take all the necessary safety precautions to prevent injury when

installing this system.

To open the case, follow these steps.

Remove the small Phillips screws that connect the top of the case to the body. There are three

screws evenly spaced across the rear and three screws evenly spaced along each side of the case.

Slide the top backwards until its front flange slides free of the faceplate then lift it off.

Insert a small, flat screw-driver blade under the battery and in one of the slots of the plastic retainer

underneath the battery.

Specifications

Table of Contents