Install The Z9000 - Dell Z9000 Manual

Install the Z9000

To install the Z9000 system, Dell Networking OS recommends completing the installation procedures in
the order presented in this chapter.
Always handle the Z9000 and its components with care. Avoid dropping the system or its field
replaceable units (FRUs).
This chapter describes the installation procedures as follows:
1. Installing the Z9000 System in a Rack or Cabinet
a. Attaching the Mounting Brackets
b. Installing the System into the Rack or Cabinet
2. Installing the Rear Mounting Brackets
3. Attaching the Ground Cable
4. Installing the QSFP+ Optics
5. Splitting QSFP Ports to SFP+ Ports
6. Installing the Solid State Drive
7. Supply Power and Power Up the System
WARNING: Electrostatic discharge (ESD) damage can occur if components are mishandled.
Always wear an ESD-preventive wrist or heel ground strap when handling the Z9000 and its
components. As with all electrical devices of this type, take all the necessary safety precautions to
prevent injury when installing this system.
Install the Z9000
4
15