Ieee Standards; Agency Compliance; Usa Federal Communications Commission (Fcc) Statement - Dell Z9000 Manual

Z9000 system
Hide thumbs Also See for Z9000:
Table of Contents

Advertisement

Table 5. DC Power Requirements
Parameter
Nominal input voltage
Maximum power supply input current
Maximum system power input

IEEE Standards

The Z9000 complies with the following IEEE standards.
802.3ae 10 Gigabit Ethernet
802.3ab 1000Base-T
802.1p L2 Prioritization
802.1Q VLAN Tagging, Double VLAN Tagging (Q in Q), GVRP
802.1s Multiple Spanning Tree Protocol
802.1w Rapid Spanning Tree Protocol
802.3ad Link Aggregation with LACP
802.1D Bridging, STP
802.3x Flow Control
802.1ac Frame Extension for VLAN Tagging
802.1x Port Based Network Access Control

Agency Compliance

The Z9000 is designed to comply with the following safety and agency requirements.

USA Federal Communications Commission (FCC) Statement

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant
to Part 15 of the FCC rules. These limits are designated to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy. If it is not installed and used in accordance to the
instructions, it may cause harmful interference to radio communications. Operation of this equipment in
a residential area is likely to cause harmful interference, in which case users will be required to take
whatever measures necessary to correct the interference at their own expense.
Properly shielded and grounded cables and connectors must be used in order to meet FCC emission
limits. Dell Networking is not responsible for any radio or television interference caused by using other
than recommended cables and connectors or by unauthorized changes or modifications in the
equipment. Unauthorized changes or modification could void the user's authority to operate the
equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
38
Specifications
-40 to -60 VDC
16.5 A @ -48 VDC
789 W
Specifications

Advertisement

Table of Contents
loading

Table of Contents