Husqvarna 533RS Operator's Manual page 13

H1158941-30,533-553RS,WestII.fm Page 13 Tuesday, July 4, 2017 8:19 AM
The guard extension is removed easily using a
screwdriver, see illustration.
Fitting a blade guard, grass blade and
grass cutter
• Hook the blade guard/combination guard (A) onto the
fitting on the shaft and secure with the bolt (L). Use the
recommended blade guard. See the Technical data
section. CAUTION! Ensure that the guard extension is
removed.
(533RS)
A
(543RS, 553RS)
A
• Fit the drive disc (B) on the output shaft.
• Turn the output shaft until one of the holes in the drive
disc aligns with the corresponding hole in the gear
housing.
• Insert the locking pin (C) in the hole to lock the shaft.
• Place the blade (D), support cup (E) and support
flange (F) on the output shaft.
• Fit the nut (G). The nut must be tightened to a torque
of 35-50 Nm. Use the spanner in the tool kit. Hold the
shaft of the spanner as close to the blade guard as
possible. To tighten the nut, turn the spanner in the
ASSEMBLY
opposite direction to the direction of rotation (Caution!
left-hand thread).
(533RS)
A
B
(543RS, 553RS)
C
A
L
G
F
E
D
B
C
G
E
F
D
B
C
–
English 13