Health O Meter 2210KL User Instruction page 7

ASSEMBLY INSTRUCTIONS (CONTINUED)
Assembling the Scale
This scale is powered by six (6) standard disposable C-cell alkaline batteries. Use the following
procedure to install the batteries:
1. Remove the scale top cover by removing the six (6)
screws (Fig. 1a).
2. Locate the battery tray (in the rear center of the scale
platform). It has a white cover that is held down with two
screws. Remove the screws and battery cover.
3. Insert new batteries. Note the orientation that is shown
on the bottom of the battery tray.
Figure 1a: Remove Scale Cover
4. Replace the battery tray cover and screws. Before
installing scale cover, press ON/ZERO to ensure scale turns
on.
5. Reinstall the scale cover. Start partially inserting the (6) screws. Once cover is centered, tighten
screws fully.
6. Place the scale platform on a table top with the display buttons facing you.
7. The acrylic tray has a built-in measuring tape. Align
the tray so that the rule is positioned over the back end
of the scale platform (Fig. 1b). Measuring Tape
8. Carefully lower the tray onto the four mounting pins
on the scale platform. When the tray is properly aligned
with the pins, gently push down on the tray over each
pin until it snaps into its locked position. When properly
positioned, there will be about a 3/8" space between the
platform top and the bottom of the tray.
Figure 1b: Install Tray
Always lift the scale by the black handles only –
never by the tray.
7