Two-Post Flush-Mount Installation - Dell S5048F-ON Setup Manual

The center extractions show how the pegs appear in both the square and nonthreaded
round holes.
Figure 3. 1U tool-less installation
2 Align and seat the front flange pegs in the holes on the front side of the vertical post.
NOTE:
3 Repeat this procedure for the second rail.
4 To remove each rail, pull on the latch release button on each flange ear and unseat each
rail.

Two-post flush-mount installation

NOTE: For more installation instructions, see the installation labels attached to the
rail assembly.
1 For this configuration, remove the latch castings from the front side of each ReadyRails
assembly, item 1.
Be sure that the rails click into place and are secure.
S5048F-ON switch installation 15