Starting Up And Temperature Regulation; Interior Accessories - Hisense HAF240A Instruction Manual

Starting up and temperature regulation

Insert the plug of the connection lead into the plug socket with protective earth contact.
When the refrigerator compartment door is opened, the internal lighting is switched on.
The temperature selector knob is located on the RH side of the refrigerator compartment.
Setting 0 means:
Off.
Turning clockwise in direction Refrigerating unit on, the latter then operating
automatically.
Setting 1 means:
Highest temperature, warmest setting.
Setting 7 (end-stop) means:
Lowest temperature, coldest setting.
At a low ambient temperature of around 16 ℃, setting 1 should be selected. At ambient
temperatures of around 25 ℃, select setting 2. If you require a lower temperature, select
setting 3 or 4.
Important!
High ambient temperatures (e.g. on hot summer days) and a cold setting on the
temperature regulator (position 6 to 7) can cause the compressor to run continuously.
Reason: when the ambient temperature is high, the compressor must run continuously to
maintain the low temperature in the appliance. The fridge will not be able to defrost since
automatic defrosting of the fridge is only possible when the compressor is not running
(see also"Defrosting" section). The result is the build up of a thick layer of frost on the
fridge rear wall.
If this happens, turn the temperature regulator back to a warmer setting (position 3 to 4.
At this setting the compressor will be switched on and off as usual and automatic
defrosting recommenced.

Interior accessories

Various glass or plastic storage shelves and wire trays are included with your appliance -
different models have different combinations. You should always slide one of the full size
glass storage shelves into the lowest set of guides, above the fruit and vegetable
containers, and keep it in this position.
The height of the storage shelves can be adjusted:
To do this, pull the storage shelf forward until it can be swiveled upwards or downwards
and removed. Please do the same in reverse to insert the shelf at a different height.
7