Installation Location; Ventilation Requirements; Your Refrigerator Needs Air; Reversing The Door - Hisense HAF240A Instruction Manual

Installation

Installation Location

The appliance should be set up in a well-ventilated, dry room. Energy use and efficient
performance of the appliance is affected by the ambient temperature.
The appliance should therefore
-Not be exposed to direct sunlight,
-Not be installed next to radiators, cookers or other sources of heat,
Your appliance will be heavy when loaded with food and must therefore be stood on a
strong firm floor.

Ventilation Requirements

For correct operation you should ensure that air could circulate freely around the back
and the top of the cabinet. There should be 100mm between the top of the cabinet and
allow 50mm between the top of the cabinet and any overhanging kitchen furniture and a
gap of 25mm on either side of the appliance.
Ensure that the appliance does not stand on the electrical supply cable. Whenever
possible the back of the appliance should be close to a wall but leaving the required
distance for ventilation.
Leveling
The appliance should be level to eliminate rocking. Ensure the appliance is upright and
both adjusters are in firm contact with the floor so that the cabinet is level. Adjust the level
by screwing out the appropriate level adjuster at the front, (use your fingers or a suitable
spanner). This appliance is heavy. Care should be taken when moving it.

Your refrigerator needs air

For correct operation this appliance must be located in a dry atmosphere, away from heat
sources, e.g. cookers, radiators, boilers and direct sunlight.
You should also ensure that air can circulate freely around the back and the top of the
cabinet. There should be 100mm between the top of the cabinet and any overhanging
kitchen furniture. Alternatively allow 50mm between the top of the cabinet and any
overhanging kitchen furniture and a gap of 25mm on either side of the appliance.

Reversing the door

The side at which the door opens can be changed from the right side (as supplied) to the
left side, if the installation site requires. Tilt the appliance slightly towards the rear and
prop it securely. Unscrew the door hinge screws and remove the hinge pin bracket. Open
the door a little way and take it out downwards.
5