Changing The Light Bulb - Hisense HAF240A Instruction Manual

switch off or turn out the circuit breaker or fuse.
Never clean the appliance with a steam cleaner. Moisture could accumulate in electrical
components, danger of electrical shock! Hot vapors can lead to the damage of plastic
parts. The appliance must be dry before it is placed back into service.
Important!
Ethereal oils and organic solvents can attack plastic parts, e.g. lemon juice or the juice
from orange peel, butyric acid, cleanser that contain acetic acid.
Do not allow such substances to come into contact with appliance parts.
Do not use any abrasive cleansers.
Remove the food from the refrigerator. Store it in a cool place, well covered. Switch the
appliance off and remove the plug from the mains, or switch off or turn out the circuit
breaker or fuse. Clean the appliance and the interior accessories with a cloth and
lukewarm water. Commercially available dish washing detergents may also be used. After
cleaning wipe with fresh water and rub dry. Accumulation of dust at the condenser
increases energy consumption. For this reason carefully clean the condenser at the back
of the appliance once a year with a soft brush or a vacuum cleaner. Check the water drain
hole on the rear wall of the fridge. Clear a blocked drain hole with the aid of the green peg
in the pack of accessories included with the appliance. After everything is dry place
appliance back into service.
Energy Saving tips
Do not install the appliance near cookers, radiators or other sources of warmth. High
ambient temperatures cause longer, more frequent operation of the compressor. Ensure
sufficient air circulation and exhaust at the appliance base and at the back wall of the
appliance. Never cover air vent openings. Do not place warm foods into the appliance.
Allow warm foods to cool first. Only leave door open as long as necessary. Do not set
temperature any colder than necessary. Keep the heat emitting condenser-the metal grille
on the rear wall of your appliance, always clean.

Changing the light bulb

Light bulb data: 220-240 V, max. 15 W
1. To switch off the appliance, set the temperature regulator to position "0".
2. Unplug the mains plug.
3. To change the light bulb, undo the screw.
4. Press the light bulb cover as shown and slide it backwards.
5. Change the defective light bulb.
6. Refit the light bulb cover and the screw.
7. Put the refrigerator back into operation.
Warning!
Before changing the light bulb, switch off the appliance and unplug it, or pull the fuse or
the circuit breaker.
9