Trouble Shooting; Noises During Operation; Correcting Malfunctions - Hisense HAF240A Instruction Manual

Noises during Operation

The following noises are characteristic of refrigeration appliances:
Whenever the compressor switches on or off, a click can be heard.
As soon as the compressor is in operation, you can hear it humming.
When refrigerant flows into thin tubes, you can hear bubbling or splashing noises.
Even after the compressor has been switched off, residue noise can be heard for a
short time.

Correcting Malfunctions

Spare parts:
The following spare parts can be ordered from your local AEG Service Force Center. You
can fit these yourself without any special skill or training, e.g.:
Butter/cheese compartment; Egg holders,
Door racks; Fruit and vegetable drawers,
Storage racks.
A malfunction may be caused by only a minor fault that you can rectify yourself using the
following instructions. Do not perform any other work on the appliance if the following
information does not provide assistance in your specific case.
Important!
Repairs to refrigerators/freezers may only be performed by competent service engineers.
Improper repairs can give rise to significant hazards for the user. If your appliance needs
repairing, please contact your specialist dealer or your local Service Center.
PROBLEM
The freezer does not operate
The freezer is too cold/ not cold enough
The fridge light does not come one
The fridge vibrates or makes noise
The compressor does not restart after a
temperature change
There is water on the floor or the racks

Trouble shooting

Check that it is properly plugged in, that the fuse has not
blown or that the circuit-breaker has not tripped.
Check the thermostat and set it to a more appropriate
temperature.
Check the bulb and change it if necessary. Also check that
the plug is correctly inserted, that the fuse has not blown
or that the circuit-breaker has not tripped.
Check that it is perfectly level. Adjust the feet.
This is normal, as the compressor only restarts after a
certain time.
The drain hole is blocked. Unclog it with a knitting needle.
10
SOLUTION