Advertisement
Advertisement
Table of Contents
Related Manuals for Piranha 900157
Summary of Contents for Piranha 900157
- Page 1 Piranha Power Vac 18V Rechargeable Vacuum Cleaner USER MANUAL MODEL: 900157...
- Page 2 IMPORTANT SAFEGUARDS When using an electric appliance, basic precautions should always be followed, including the following: READ ALL INSTRUCTIONS BEFORE USING THIS RECHARGEABLE VACUUM To reduce the risk of fire, electric shock, or injury: Ø This product is designed for domestic use only. Ø Do not charge this unit outdoors. Ø Do not allow to be used as a toy. Close attention is necessary when used near children, pets or plants. Ø The appliance is not intended for use by young children or infirm persons without supervision. Ø Young children should be supervised to ensure that they do not play with the appliance. Ø Do not use with damaged cord or plug. If unit is not working as it should, has been dropped, damaged, left outdoors, or immersed into water, return it to the distributor before continuing use. If the charger cord is damaged, it must be replaced by the manufacturer or a similarly qualified person to avoid a hazard. ...
- Page 3 Thank you and congratulations for choosing the Piranha Cordless Power Vac with the ultimate 18V suction power The Piranha Cordless Power Vac has a powerful 18V battery capacity giving the Piranha more than double the power of most rechargeable hand held vacuums. Comes equipped with a 3 piece extension tube for upright vacuuming, an adjustable crevice tool for hard to reach places, a larger floor brush and an ...
- Page 4 HOW TO ASSEMBLE AND USE The Power Vac comes with a 18V rechargeable battery that must be charged initially for 24 hours prior to operating for the first time and 12 hours thereafter. 1) The Storage Unit is also the Recharge Stand and has a Charging Hole for the Charging Jack to lock into place. Main Body Hook 2) Place the Charging Jack in beneath the Storage Stand into the Charging Hole. 3) Twist the Charging Jack to the left to lock into the Charging Hole. 4) To Place the Power Vac onto the Recharge / Storage Unit, sliding the Main Body onto Main Body Hook, as indicated on the above picture. 5) While sliding the Power Vac onto the main body hook, the main body must also clip onto the Charging Jack. The Power Vac has been fitted on the Storage Unit correctly when the Charging Light Indicator is on. NOTE: The Indicator light must be on to charge the battery 6) ...
- Page 5 ACCESSORIES 1) The Floor Brush, Flexible Crevice Tool or Interchangeable Brush and Upholstery tool can be attached directly onto the Dust Container or on the end of the Extension Tubes. 2) To use the extension tubes, you may choose to utilize all three tubes for a longer extension or only one or two tubes for shorter extensions. MAINTENANCE 1) Ensure that the Dust Filter is fitted in the Dust Container correctly. Never use the Power Vac without the Dust Filter, as this will damage the motor. 2) Press the Dust Container Release Button to unclip the Dust Container from the Main Body. ...
- Page 6 5) The Storage Unit can be wall mounted for user convenience. Drill three holes as shown below in the chosen position of the wall. Insert the rivets then fix the stand to wall with the three screws provided. NOTE: To mount on Hollow Plaster Walls, you may require using a special rivet suitable to your type of wall (not included) available from all good hardware stores. 6) Never open the battery compartment. If required to do so, care should be taken and we suggest that you contact the distributor for further instruction. 7) The battery contains nickel metal hydride (NiMH) and must be disposed of properly. You should contact your local waste collector for further information on the correct disposal procedure of these types of batteries. TROUBLESHOOTING GUIDE PROBLEM REMEDY I’m pressing the ON switch, but the Battery needs charging. (Make sure red unit is not working indicator light is on while charging). Check electrical outlet. Unit may need servicing. Batteries need to be changed Suction is reduced or does not Check dust container is empty. collect dust. If full, empty dust container. Check Air duct has no obstructions. Unit needs to be recharged. Clean Dust Filter If using extension tubes, check for obstructions and remove. Dust is escaping from the dust Dust container may be full, check and container empty. Dust Filter may be damaged Dust filter is not in place properly...
Need help?
Do you have a question about the 900157 and is the answer not in the manual?
Questions and answers