Table of Contents
Advertisement
Pilot flame (Figure 6)
When the devices are preset for the use of butane /
propane gas, the set screw of the pilot flame is turned
all the way to the left.
If you want to change from butane / propane gas
operation to natural gas operation, you must unscrew
the set screw, until the pilot flame is correctly set.
The pilot flame is correctly set when the flame does not
extinguish while being quickly turned from maximum to
minimum setting. The flame should be as low as
possible and at every hole half as large as a pinhead.
6. Cleaning and maintenance
6.1 Safety advice
o Before beginning with repair or cleaning works make switch-off the device and has
cooled down.
o Do not use any acid agents and make sure no water ingresses the device.
CAUTION!
The device is not suited for direct washing via water jets.
Therefore, you must not use any kind of pressure water jet for cleaning the device!
6.2 Cleaning
o Clean the device regularly.
o Do not wash the device in a dish washer at any time.
o Clean the batter spreader and batter spatula regularly using warm water und a mild
detergent.
Cleaning the base
o Let the device cool off before cleaning. This will prevent you from burns. Clean the
base of the device with a soft, sponge soaked in mild detergent. Do not use any
scouring agents, abrasives or steel/scratch/wire brushes.
Cleaning the Crêpe Plates
o Remove baking residues after baking while they are still warm using a paper towel
or a soft, damp cloth.
Figure 6
- 27 -
Advertisement
Table of Contents
