Table of Contents
Advertisement
-
The Crêpe Plate has not been heated up sufficiently. Heat up the Crêpe Plate
for some more time;
Scrape off the burnt batter and heat up the plate one more time.
-
The batter just cooks:
The batter is to liquid or the Crêpe Plate too hot.
-
The Crêpe Plate sticks:
-
Apply some fat on the Crêpe Plate using some frying oil, yolk or butter.
Settings
The changeover to a different type of gas may only be performed by qualified personnel.
Replacing the injector (burner injector)
In case the device is installed already you must shut the gas valve of the the gas pipe
gas cylinder.
•
Remove, if necessary, the Crêpe Plates and
turn the device upside down.
•
Open the air supply as far as possible be
moving the adjusting ring (Figure 5 Pos. 1).
•
Remove the injector (Figure 5, Pos. 2) using a
screw-wrench of size 10.
•
Replace the injector and gasket.
•
Set the adjusting ring for air supply to 12 mm
and screw it tight.
•
Put the old injector back into the bag with the
other injectors and store it carefully. Pay
attention to the paragraph „Start-up" of this
manual.
- 26 -
Figure 5
Advertisement
Table of Contents
