Related Manuals for Bartscher 1043423
Summary of Contents for Bartscher 1043423
- Page 1 1043413 1043423 Bedienungsanleitung Gas-Crêpegeräte D/A/CH Seite 1 bis 14 Instruction manual Gas Crêpe Makers GB/UK from page 15 to 28 V3/1013...
- Page 2 5.2 Installation and connection .................. 23 5.3 Operation ......................23 6. Cleaning and maintenance ..................27 6.1 Safety advice ....................... 27 6.2 Cleaning ......................27 6.3 Safety instructions for maintenance ..............28 Bartscher GmbH Franz-Kleine-Str. 28 D-33154 Salzkotten phone: +49 (0) 5258 971-0 Germany fax:...
-
Page 3: General Information
1. General information 1.1 Information about the instruction manual This instruction manual contains information about the installation, operation and maintenance of the device and should be consulted as an important source of information and reference guide. Awareness of the safety instructions and instructions for use in this manual will ensure the safe and correct use of the device. -
Page 4: Liability And Warrantees
1.3 Liability and Warrantees All the information and instructions in this manual take into account standard safety regulations, current levels of technical engineering as well as the expertise and experience we have developed over the years. The instruction manual was translated with all due care and attention. However, we do not accept liability for any translation errors. -
Page 5: Safety
2.Safety This section provides an overview of all important safety aspects. In addition every chapter provides precise safety advice for the prevention of dangers which are highlighted by the use of the above mentioned symbols. Furthermore, attention should be paid to all pictograms, markers and labels on the device, which must be kept in a permanent state of legibility. -
Page 6: Intended Use
o The device should never be left unattended during operation. Keep away from children and other unqualified persons. o Keep this manual in a safe place. When passing on/selling the device to a third party, the manuals must be handed over along with the device. o Every person using the device must act in accordance with the manuals and under consideration of the safety advice. -
Page 7: Transport, Packaging And Storage
3. Transport, packaging and storage 3.1 Delivery check Please check the delivery upon completeness and transport damage immediately after receipt. In case of visible damage do not accept or accept the delivery with reservation only. Note the extent of damage on the carrier’s bill of delivery. Trigger off the complaint. Hidden damages should be reclaimed immediately after notice, as claims for damages can only be asserted within the effective period for complaints. -
Page 8: Technical Data
4. Technical data 4.1 Overview of parts Figure 1 Top view Figure 1 1 => Connection nipple for butane / propane gas 2 => Connection nipple for tube Figure 2 Top view Figure 2 1 => Safety thermocouple 2 => Spark plug Figure 2 Top view 3 =>... -
Page 9: Technical Specification
4.1 Technical specification Gas Crêpe Makers Description Single Double 1043413 1043423 Code-no.: Power: 6,0 kW 2 x 6,0 kW Temperature stages: 1 – 8 Dimensions: W 430 x D 430 x H 195 mm W 830 x D 430 x H 195 mm Size of the Crêpe... -
Page 10: Installation And Connection
ATTENTION! The device may only be used in a properly ventilated room and only in compliance with the national requirements for the supply of combustion air and the avoidance of accumulation of hazardous quantities of unburned gas. In case the national regulations do not allow such action, the device may be operated outdoors only. - Page 11 • Insert the flame between Crêpe Plate and base and press the control knob in this position in order to ignite the burner fully. • Keep the control knob pressed for 5 to 10 seconds in order to activate the safety system with the thermocouple.
- Page 12 Figure 4 • Apply a small amount of fat on the Crêpe Plate before first use. Afterwards just apply fat when you find it is required. • Pour the appropriate batter on the Crêpe Plate and spread it with the provided batter spreader.
- Page 13 The Crêpe Plate has not been heated up sufficiently. Heat up the Crêpe Plate for some more time; Scrape off the burnt batter and heat up the plate one more time. The batter just cooks: The batter is to liquid or the Crêpe Plate too hot. The Crêpe Plate sticks: Apply some fat on the Crêpe Plate using some frying oil, yolk or butter.
-
Page 14: Cleaning And Maintenance
Pilot flame (Figure 6) When the devices are preset for the use of butane / propane gas, the set screw of the pilot flame is turned all the way to the left. If you want to change from butane / propane gas operation to natural gas operation, you must unscrew the set screw, until the pilot flame is correctly set. -
Page 15: Safety Instructions For Maintenance
Only a qualified technician and using original spare parts and accessories should carry out repairs and maintenance of the device. Do not attempt to repair the device yourself. Bartscher GmbH Franz-Kleine-Str. 28 D-33154 Salzkotten phone: +49 (0) 5258 971-0...