Table of Contents
Advertisement
The display shows
setting "0000") and press the «OK» softkey.
The display shows
code. Finish by pressing the «OK» softkey.
The display shows
code again. Finish by pressing the «OK» softkey. The display briefly
shows
Entry stored !
Press the cancel key for approx. 2 seconds to return to the standby mode.
.....
•
Note
Only authorised service staff can reset the PIN code! Thus make sure
that you do not forget your PIN code!
•
If you enter a wrong PIN code, the display shows
Press the cancel key (or wait a few seconds) after which you are
requested to re-enter the correct code.
Setting the date and time
To set the date and time on your Vtech GEMINI follow the procedure below:
Open the menu by pressing the «Menu» softkey.
Select the menu entry
Select the menu entry
The display reads:
format and press the «OK» softkey.
The display reads:
format and press the «OK» softkey.
The new date and time are now stored.
Press the cancel key for approx. 2 seconds to return to the standby mode.
.....
Note
The time and date setting is stored in the base station. This means that
each change of the time and/or date applies to all other handsets which are
logged on to the same base station.
Selecting the Flash time
A so-called 'flash'-signal is sometimes required to perform special network service functions. Ask your service provider for further
details on when to use such a flash signal.
Your Vtech GEMINI has a dedicated key
procedure below:
Open the menu by pressing the «Menu» softkey.
Select the menu entry
Select the menu entry
The current setting is indicated by a tick mark. Select the desired flash time
with the navigation keys, e.g.
Select one of the following values (in msec):
Old PIN:
. Enter the current PIN code (factory
New PIN:
requesting you to enter a new 4-digit PIN
Repeat PIN:
requesting you to enter the new PIN
. The new PIN code is now stored.
Settings
and press the «OK» softkey.
Date/time
and press the «OK» softkey.
Enter date:
Enter the current date in the indicated
Enter time:
Enter the current time in the indicated
to generate this flash signal. To select the length of the flash signal, follow the
Settings
and press the «OK» softkey.
Flash time
and press the «OK» softkey.
Flash 100ms
Wrong PIN:
Advertisement
Table of Contents
