Advertisement
CONTROLS AND DISPLAY
PLEASE READ THE FOLLOWING INSTRUCTIONS CAREFULLY
TURNING YOUR DEVICE ON/OFF
Power On: Take your device out of the box and place it flat on a level
surface. Press the power button (located on the rear of your device)
once. Check the battery LED indicator (located in the center of your
device). The battery indicator light should be lit, indicating the device
is powered on.
Power Off: Press the power button once.
MAT SENSOR
There are four sensors under the foot mats on your H1 scooter. When
the user steps off the scooter mats, it will automatically initiate
self-calibration.
When riding the scooter, you must ensure you are stepping on the foot
mats. Do not step or stand on any other area of your scooter.
Do not put items on the foot mats. Doing so will make the H1 turn on,
and increase the probability of collision and cause injury to people,
riders, or damage the device.
BATTERY INDICATOR
The display board is located in the middle of the H1 scooter.
• Green LED light indicates the device is charged above 20 percent.
• Yellow LED light indicates the power is under 20 percent.
• Red LED light indicates the power is down to 10 percent or lower.
When the LED light turns red, please recharge the device.
STATUS INDICATOR
When the operator triggers the foot mats, the LED Status Indicator will
light up, which indicates that the Hover-1 is now ready for use.
When the system has an error during operation, the status LED light will
turn red (for more details see SAFETY ALERTS).
7
Advertisement
