ProForm PFEX01416.1 User Manual page 11

5. Note: You can attach your own saddle to the
Saddle Carriage (4) if desired. Loosen the
attachment hardware (not shown) beneath the
Saddle (5), and remove the Saddle. Then, attach
your own saddle and retighten the attachment
hardware.
Orient the Saddle Carriage (4) as shown.
Loosen the Adjustment Handle (47), and slide
the Saddle Carriage (4) into the Saddle Post (3).
Slide the Saddle Carriage to the desired posi-
tion, and tighten the Adjustment Handle.
Then, attach an M4 Washer (54) and the
Carriage Cover (91) to the Saddle Carriage (4)
with an M4 x 14mm Screw (117).
6. See step 8. If the Handlebar Clamp (28) and
four M6 x 16mm Screws (110) are preattached
to the Handlebar Carriage (105), remove them
and set them aside until step 8.
While a second person holds the Handlebar Post
(6) near the Frame (2), connect the Handlebar
Post Wire (68) to the Frame Wire (130). Then,
untie and discard the wire tie (C) on the Frame
Wire. Insert the excess wire into the Frame.
Tip: Avoid pinching the wires. Loosen the
indicated Adjustment Handle (47), and insert
the Handlebar Post (6) into the Frame (2). Move
the Handlebar Post upward or downward to the
desired position, and tighten the Adjustment
Handle.
5
3
54
91
117
47
6
Avoid pinching
the wires
2
11
5
4
105
6
68
130
47
C