Fujitsu LifeBook N series User Manual page 76

Problem
PC Card Problems
PC Card does not The card is not properly
work or locks up installed.
the system.
The card may have been
installed while an
application was running,
so your system is not
aware of it.
Your software may not
have the correct software
driver active.
You may have the wrong I/
O address selected for
your PC Card device.
Your PC Card device and
another device are
assigned the same I/O
address.
The card may have been
"removed" using the
Unplug or Eject Hardware
utility.
68
Possible Cause
Remove and re-install the card.
Close the application and restart your
LifeBook notebook.
See your software documentation and activate
the correct driver.
See PC Card documentation to determine the
required I/O address. Change the BIOS
settings.
Check all I/O addresses located within the
BIOS setup utility and any other installed
hardware or software to make sure there are
no duplications.
If Unplug or Eject Hardware utility has been
used to remove the card, the system will not
recognize it, even if it is still in the slot.
Remove the card and reinstall it. If that isn't
successful, reboot the system.
Possible Solution