Checklist - Kaba simplex 7106 series Installation Instructions Manual

CHECKLIST

Use this checklist to make sure that

everything has been included. J
A – Front lock
B – Inside combination change assembly
C – Reinforcing plate
D – Inside rim deadlocking latch
E – Strike box
F – Screw pack
a. Flat strike plate
b. Six 1 3 ⁄ " (44 mm) screws
4
4 for inside rim deadlocking latch,
2 for strike box
c. Three 1" (25 mm) flat head screws for strikes
d. Two 2 3 ⁄ " (70 mm) round head break away thru bolts for reinforcing plate
4
e. Two 3" (76 mm) flat head thrubolts for inside combination change assembly
f. Two 2 ⁄ " (60 mm) flat head thru bolts for inside combination change
3
8
assembly
g. Two 2" (51 mm) flat head thru bolts for inside combination change assembly
Template (in center of booklet)
DETERMINE THE HAND OF YOUR DOOR
Many of the installation instructions refer to
the handing of your door. The hand of the
door is determined with the door in the
closed position, from the exterior or pushbut-
ton side of the door.
A) Right Hand Door. Door opens inward
(push). Hinged on the right side.
B) Left Hand Door. Door opens inward
(push). Hinged on the left side.
C) Right Hand Reverse Door. Door opens
outward (pull). Hinged on the right side.
D) Left Hand Reverse Door. Door opens out-
ward (pull). Hinged on the left side.
2
C
A
D E
F
b
a
c
3
f 2 / "
8
d
2 3 / "
4
e 3"
g 2"
RH - Right Hand
A
LH - Left Hand
B
RHR - Right Hand Reverse
C
LHR - Left Hand Reverse
D
A. DETERMINING THE LOCK
LOCATION
Install the lock with exterior thumbturn hole at
least 7" (18 cm) above your primary lockset so it is
comfortable to operate and not in the way when
you turn the door knob (See Figure 1-1). Minimum
stile width recommended: 4" (102 mm).
B. MARKING THE DOOR
B-1 Doors Opening Inward
a. Fold the template (A) on the solid line (B).
b. Tape the template securely to the inside of
the door so that the fold is properly aligned
with the edge of the door (See Figure 2-1).
c. Use a center punch to mark the ten drilling
points indicated on the template.
d. Remove the template.
B-2 Doors Opening Outward
a. Fold the template (A) on the dashed line (B).
b. Tape the template securely to the inside of
the door (C) so that the dashed line is
aligned with the face of the door jamb (D)
(See Figure 2-2).
c. Use a center punch to mark the ten drilling
points indicated on the template.
d. Remove the template.
Note: You may install the strike (E) at this point.
See Section I - Installing the Strike.
4"
(102 mm)
7"
(18 cm)
1-1
A B
2-1
D
B
A
E
C
2-2
3