4.OPERATION AND USE
4.2 Color screen wire controller function introduction
(1) Booting and shutdown
As shown in figure 1.1:
In shutdown status, click
In booting status, click
(2) Mode switch and target temperature Setting
2.2 1 Mode switch
In the main interface, click mode button or inlet water temperature setting
button, interface displays as follows:
Click the refrigeration mode button
heating mode button
Note: when the unit is designed for single automatic mode or single
thermal mode, the mode can not be switched.
2-2 Target temp. setting
Click the temperature set button
①
then the unit will be booted
①
then the unit will be shut down.
④
③
③
then you can select the corresponding mode.
②
①
, automatic mode button
④
, you can set the target temperature.
11
①
②
or