Time Setting - ZyXEL Communications P-3202HN-Ba User Manual

18.3 Time Setting

To change your IAD's time and date, click Maintenance > System > Time
Setting. The screen appears as shown. Use this screen to configure the IAD's
time based on your local time zone.
Figure 111 System > Time Setting
The following table describes the fields in this screen.
Table 68 Time Setting
LABEL
Current Time
Current Time
Current Date
Time and Date
Setup
Get from Time
Server
Time Protocol
Time Server
Address
Apply
Cancel
IAD User's Guide
DESCRIPTION
This field displays the time of your IAD.
Each time you reload this page, the IAD synchronizes the time with the
time server.
This field displays the date of your IAD.
Each time you reload this page, the IAD synchronizes the date with the
time server.
Select this radio button to have the IAD get the time and date from the
time server you specified below.
Indicates that the IAD uses the NTP format, which displays a 4-byte
integer giving the total number of seconds since 1970/1/1 at 0:0:0.
Enter the IP address or URL (up to 20 extended ASCII characters in
length) of your time server. Check with your ISP/network administrator
if you are unsure of this information.
Click Apply to save your changes back to the IAD.
Click Cancel to begin configuring this screen afresh.
Chapter 18 System
213