Weslo gllider III User Manual page 7

5. Route both pulse wires up through the Upright (3) as
shown.
Attach the T-bar (7) to the Upright (3) with four M6 x
16mm Button Screws (55) and four M6 Split
Washers (58).
6. The Console (4) requires two 1.5V batteries.
Alkaline batteries are recommended.
To install batteries, first locate the battery clip under
the Console (4). Insert two batteries into the battery
clip as shown. Make sure that the batteries are
turned so the negative ends of the batteries
(marked "–") are touching the springs in the
battery clip.
7. Connect the Extension Wire (40) and the two pulse
wires to the corresponding wires on the Console (4).
If your Console (4) has an earthed wire, attach it to
the Upright (3) with an M4 x 10.5mm Screw (70).
Insert any excess wiring down into the Upright (3).
Do not push the Upper Cable (24) down into the
Upright.
Next, attach the Console (4) to the Upright (3) with
four Console Screws (69).
Press the Resistance Knob (8) onto the Resistance
Control (24). Make sure that the mark on the
Resistance Knob is correctly aligned.
5
55
6
Battery
Clip
7
Console
Wires
24
40
69
7
58
7
58 55
Pulse
Wires
3
4
Batteries
8
4
Earthed
Wire
70
Pulse
Wires
24
3