Assembly - ProForm Hot cross buns User Manual

ASSEMBLY

Place the included parts in a cleared area and remove the packing materials. Do not dispose of the packing
materials until assembly is completed. Assembly requires the included allen wrench
phillips screwdriver
See the drawings below for help identifying the small parts used during assembly. The number in parenthesis
below each drawing is the key number of the part, from the PART LIST on page 10. The number following the
key number is the quantity required for assembly. Note: If a part is not found in the parts bag, check to see if
it has been preassembled.
M8 x 16mm Bolt
(34)–4
M8 x 66mm Button
Bolt (37)–2
1. Press a Stabilizer Endcap (21) onto each end of the
Rear Stabilizer (2).
Attach the Rear Stabilizer (2) to the Base (1) with
two M8 x 71mm Button Bolts (44), two M8 Split
Washers (52), and two M8 Nylon Locknuts (38).
See the inset drawing. Press a Stabilizer Endcap
(21) onto each side of the front of the Base (1).
, adjustable wrenches
M8 Split
Washer (52)–10
M8 x 25mm Button
Screw (54)–2
M8 Nylon
Locknut (38)–12
M8 x 71mm Button
1
1
38
21
4
and your own
, and rubber mallet
M3 x 15mm
Screw (35)–4
M8 x 38mm Button
Bolt (45)–4
Bolt (44)–2
38
2
52
1
21
.
21
52
44