Audi TT Roadster 2016 Owner's Manual page 273

should only be used as a temporary meas­
ure.
- Do not allow the sealant to come into con­
tact with your eyes, skin or clothing.
- If you do come into contact with the sealant
immediately rinse the eyes or skin affected
with clean water.
- Make sure you do not breathe in the fumes.
- If you accidentally swallow tyre sealant, im-
mediately rinse your mouth thoroughly and
drink a large amount of water. Do not in­
duce vomiting. Immediately contact a doc­
tor.
- Change clothing immediately if it becomes
soiled with the tyre sealant.
- If any allergic reactions should occur get
medical help immediately.
- Keep the sealant away from children.
(©)
Note
- If sealant should leak out, leave it to dry.
When it has dried, you can pull it off like a
piece of foil.
- Observe the expiry date stated on the seal­
ing compound can. Have the sealing com­
pound exchanged by a qualified workshop.
- Interference to the radio reception may oc­
cur when using the compressor*.
- Please observe the relevant regulations.
Tyre repairs
Applies to: vehicles with tyre repair kit
Components of the tyre repair kit
Fig. 228
0
<t
0
N
,.....
N
......
0
,.....
Vl
CX)
Connecting the tyre repair kit
Fig. 229
Important: The tyre repair kit must be at hand
and ready for use ¢ page 2 70.
Setting up the tyre repair kit
� Open the flap@on the compressor¢
� Pull the connector©
® including the pressure gauge out of the
housing.
� Screw the compressor
@ of the tyre sealant
� Place the tyre sealant can (flange facing down)
into the opening@
sor.
� Unscrew the dust cap from the valve of the
damaged tyre.
� Screw the filler
c:::>Fig.
229.
� Insert the connector©¢
in the vehicle.
� Switch on the ignition.
Inflating the tyre
� Move the switch@¢
<.O
a, sor to position I.
N
>
0
� Pump the tyre up to 2.0 to 2.5 bar and monitor
the pressure shown on the pressure gauge.
� If the tyre pressure remains lower than the val­
ue specified above, remove the filler hose and
drive 10 metres forwards or backwards at a low
speed so that the sealant can spread evenly in
the tyre. Now pump the tyre up again¢
.&_
WARNING
- Please observe the manufacturers' safety
notes on the compressor and the instruc­
tions supplied with the tyre sealant can.
Mobility
and the compressor hose
hose® onto the flange
can@.
on the flap of the compres­
hose@ onto the valve
Fig.
228 into a socket
Fig.
229 on the compres­
N
a,
N
>
0
Fig.
228.
0
_A .
271