Delta Scottsdale Assembly And Use Manual

Toddler bed

Download this manual

THIS PRODUCT IS NOT INTENDED FOR INSTITUTIONAL OR COMMERCIAL USE.

If you have any questions or missing parts, contact us. DO NOT return product parts to the store

from where it was purchased before contacting Delta Children's Products Customer Service.

Make sure that all pre-assembled parts are tight. The appearance of your product may be different

from that pictured in this booklet.

To register your product for important safety alerts and updates to your product

please visit http://deltaenterprise.com/register.asp

JULY 19, 2010 7151-R2

READ ALL INSTRUCTIONS BEFORE

ASSEMBLY AND USE.

KEEP INSTRUCTIONS FOR FUTURE USE.

ADULT ASSEMBLY REQUIRED

DUE TO THE PRESENCE OF SMALL PARTS DURING

ASSEMBLY, KEEP OUT OF REACH OF CHILDREN UNTIL

ASSEMBLY IS COMPLETE.

Customer Service:

Web Site: www.deltachildrensproducts.com

Delta Children's Products

114 West 26th Street

New York, NY 10001

Tele.212-645-9033

Required Tools

Flat Head

Screwdriver

(not supplied)

Conforms to

ASTM F1821

Safety Standards

Page 1 If you have any questions or missing parts, contact us. DO NOT return product parts to the store from where it was purchased before contacting Delta Children’s Products Customer Service. Make sure that all pre-assembled parts are tight. The appearance of your product may be different from that pictured in this booklet.
Page 2 - Do not scratch or chip the finish. - Inspect the product periodically, contact delta children's products for replacement parts or questions. - Do not store the product or any parts in extreme temperatures and conditions such as a hot attic or a damp, cold basement.
Page 3 PARTS: MAKE SURE THAT ALL PRE-ASSEMBLED PARTS ARE TIGHT. C. LEFT HEADBOARD LEG(1) A. HEADBOARD TOP RAIL(1) A1. HEADBOARD MIDDLE RAIL(1) D. RIGHT HEADBOARD LEG(1) E. FOOTBOARD RAIL(1) F. RIGHT FOOTBOARD LEG(1) B. HEADBOARD(1) J. RIGHT BACK H. LEFT BACK SIDE RAIL (1) SIDE RAIL (1) G.
Page 4 PARTS: MAKE SURE THAT ALL PRE-ASSEMBLED PARTS ARE TIGHT. R. M6x90 mm BOLT x 4 S. M6x76 mm BOLT x 11 T. M6x63 mm BOLT x 14 U. M6x45 mm BOLT x 2 V. BARREL NUT x 26 W. Φ4.5x30 mm METAL PIN x 2 X.
Page 5 STEP 1 STEP 2...
Page 6 STEP 3 STEP 4...
Page 7 STEP 5 STEP 6...
Page 8 STEP 7 STEP 8...
Page 9 STEP 9 STEP 10...
Page 10 STEP 11 STEP 12 THE ROUND EDGES ON THE PLATE (PART Y) MUST FACE...
Page 11 STEP 13 FINAL...
Page 12 Delta. To register your product for important safety alerts and updates to your product please visit http://deltaenterprise.com/register.asp...