Table of Contents
Advertisement
1. Loosen the Lock Knob (68) on the right side of the
Frame (1). Slide the Seat Frame (3) out until it
stops. Tighten the Lock Knob.
Identify the Rear Stabilizer (73), which has Wheels
(41) on the ends. Attach the Rear Stabilizer to the
Seat Frame (3) with two M10 x 70mm Carriage Bolts
(62) and two M10 Nylon Locknuts (71).
2. Attach the Front Stabilizer (72) to the Frame (1) with
two M10 x 70mm Carriage Bolts (62) and two M10
Nylon Locknuts (71).
3. Attach the Upright (2) to the Frame (1) with three
M10 x 25mm Button Screws (25) and three M10
Split Washers (26). Be careful not to pinch the
Reed Switch Wire (13) or the Resistance Cable
(10).
4. The light therapy pod requires two GX 24 Q-3 Base
Light Tubes (88). Remove the four #8 x 3/8Ó Screws
(96) from the back of the Left Light Cover (91).
Remove the Left Light Cover. Insert a Light Tube
into the Light Fixture (87). Reattach the Left Light
Cover with the #8 x 3/8Ó Screws.
Install a Light Tube (88) into the right side of the light
therapy pod in the same manner.
1
1
2
62
3
2
26
25
4
88
96
7
68
3
71
71
73
41
62
72
1
71
25
26
25
13
10
1
91
87
Advertisement
Table of Contents
