ProForm PFEL1303.3 User Manual page 19

HOW TO CONNECT TO YOUR COMPUTER
Note: If your computer has a 1/8" LINE OUT jack,
see instruction A. If your computer has only a
PHONES jack, see instruction B.
A. Plug one end of a 1/8" to 1/8" stereo audio cable
(available at electronics stores) into the jack
beneath the console. Plug the other end of the
cable into the LINE OUT jack on your computer.
A
B. Plug one end of a 1/8" to 1/8" stereo audio cable
(available at electronics stores) into the jack
beneath the console. Plug the other end of the
cable into a 1/8" Y-adapter (available at electronics
stores). Plug the Y-adapter into the PHONES jack
on your computer. Plug your headphones or speak-
ers into the other side of the Y-adapter.
B
Audio
Cable
Headphones/Speakers
LINE OUT
Audio
Cable
PHONES
1/8"
Y-adapter
HOW TO USE IFIT.COM VIDEO PROGRAMS
To use iFIT.com video program, the elliptical exerciser
must be connected to your VCR. See HOW TO CON-
NECT TO YOUR VCR on page 18. To purchase
iFIT.com videocassettes, call the toll-free tele-
phone number on the front cover of this manual.
Follow the steps below to use an iFIT.com video pro-
gram.
Turn on the console.
1
See step 1 on page 13.
Select the iFIT.com mode.
2
To use an iFIT.com video
program, press the
iFIT.com button. The
iFIT.com indicator will light
and the letters IF will
appear in the small display.
Insert the iFIT.com videocassette.
3
Insert the videocassette into your VCR.
Press the play button on your VCR.
4
A moment after the play button is pressed, your
personal trainer will begin guiding you through
your workout. Simply follow your personal trainer's
instructions.
The video program will function in almost the
same way as a Smart program (see step 3 on
page 15). However, an electronic "chirping" sound
will alert you when the resistance level and/or the
target pace is about to change.
Note: If the resistance level and/or the target
pace does not change when a "chirp" is heard:
• Make sure that the iFIT.com indicator is lit.
• Adjust the volume of your VCR. If the volume
is too high or too low, the console may not
detect the program signals.
19