Miller 14-Pin Insight Core CE Owner's Manual page 35

G. Configuring A WiFi Connection Using A Static IP Address Per An Embedded Server Page
.
In order to setup a WiFi connection with a static IP address, the unit must first be connected to a wired ethernet connection. Before proceeding
with installation, confirm that your wired Ethernet line has open access to the Internet by plugging your laptop into the network jack using a CAT5
patch cord and browsing to a known external website. If successful, continue the process below. If not, contact your company's IT support staff.
1. Click on Connect Module via Wired Ethernet.
Figure 4-24. Selecting Wired Ethernet Configuration Settings
2. Connect your PC directly to the Insight device network port (RJ45 jack) with an Ethernet cable (common CAT5 or CAT6).
3. Change your PC network adapter settings in order to interface with the Insight server page.
4. For Windows computers, go to Control Panel / Hardware & Sound / Network & Internet / Network & Sharing Center / Change Adapter Settings.
These settings will vary by computer.
5. Right click on your Local Area Connection, choose Properties.
6. Click on Internet Protocol Version 4 (TCP/IPv4), and click the Properties button.
7. Make note of your current network settings before proceeding.
8. Select Use the following IP address radio button.
9. Set a static IP address to 169.254.0.1 or alternative (the last digit can be anything except 2).
10. Set the Subnet Mask to 255.255.255.0
11. Click OK when finished and close all network settings windows.
.
All of these network adapter changes need to be reversed when you are finished with installations in order to reconnect to your corporate network.
12. Close all open network setting dialog boxes and browsers. Open another browser window on your desktop and wait approximately 30 seconds.
Then, if firmware version being used is 1.19.10 or later, type the IP address 169.254.0.2 directly into the browser's URL text box (in place of a
website name). If firmware version is prior to 1.19.10 use the IP address 169.254.0.2/wifi.shtm.
.
If the Static Assigned IP address cannot be accessed, turn the power source off, insert the USB stick and power the unit on. This will write a text
file to the USB stick labeled IP_MAC_LIC_ADDR.txt. Open this file using Notepad to verify the Static Assigned IP address that you are attempting
to browse to is the same IP address of the Insight device as listed in the IP_MAC_LIC_ADDR.txt file.
266 098 Page 29