Miller 14-Pin Insight Core CE Owner's Manual page 32

E. Connecting The Insight Core Module To Wireless WiFi
.
Once WiFi Settings is selected, use the information supplied by your IT department [from your Corporate Network Connectivity Survey of Requirements
(see Section 4-6 for information on obtaining survey)].
Connection Information required for initial installation of each unit purchased.
1. Click the button Connect Module via Wireless / WiFi.
2. Enter the name/SSID of your wireless network.
3. Enter the security type of your wireless network.
4. Enter the security key (password) of your wireless network. (Note: this field will be disabled if your network is an "open" system.)
.
These settings will work for all Axcess Insight Core modules being installed and will only need to be done once during installation of additional
units.
5. By default, the Axcess Insight Core module will communicate to the Internet on port 80. If your wireless network routes internet traffic over any
other port, enter that port number in the box.
.
To continue with firmware installation, proceed to Section 4-11.
266 098 Page 26
Figure 4-21. Entering Security Key For Wireless Network