ProForm PFANBE3525.0 User Manual page 12

Proform user manual weight bench pfanbe3525.0
Table of Contents

Advertisement

20. Orient the Locking Bar (50) as shown. Slide the
Barbell (51) through the Left Barbell Guide (52),
the Locking Bar, and the Right Barbell Guide (53).
Make sure that the Barbell is centered in the
Barbell Guides. Engage the Locking Bar into the
Uprights (43) at the lowest position.
21. Hand tighten an M8 x 20mm Button Screw (16)
into the Left Barbell Guide (52).
Slide a Weight Stop (69) onto the Barbell (51).
Hand tighten an M6 x 15mm Button Screw (17)
into the Weight Stop. Make sure that the Screw
is tightened enough to engage the hole (see
drawing 20) in the Barbell.
Repeat this step on the other side of the
Barbell (51).
Tighten the screws used in this step, and the
bolts and locknuts used in steps 11–15 and
17–19.
Press two Center Base Feet (60) onto the Center
Rack Base (39). Press the Rear Upright Foot (59)
onto the Rear Upright (41). Press two Front
Upright Feet (64) onto the Front Uprights (43).
22. Route a Cable (61) up through the Top Frame
(45) and over a Pulley (63). Attach the Pulley
inside the Top Frame with an M10 x 67mm Bolt
(86), two M10 Washers (80), two 16mm x
12.5mm Spacers (76), and an M10 Nylon Locknut
(77).
23. Route the Cable (61) over a Pulley (63) and down
through the Top Frame (45). Attach the Pulley
inside the Top Frame with an M10 x 67mm Bolt
(86), two M10 Washers (80), two 16mm x
12.5mm Spacers (76), and an M10 Nylon Locknut
(77).
20
53
50
21
60
52
43
22
80
77
76
61
23
80
77
12
52
43
51
41
59
39
51
16
17 69
64
45
63
76
80
86
63
76
45
76
61
80
86
Hole
60

Advertisement

Table of Contents
loading

This manual is also suitable for:

Xp 300

Table of Contents