Advertisement
Important notice for vehicles equipped with Mobile-Ease
If the vehicle is equipped with Mobile-Ease Bluetooth™ device the wiring must be connected in the following
order.
A. Disconnect the factory wiring from the radio. (Large and Medium sized connectors only)
B. Connect the two corresponding connectors of the Mobile-Ease harness to the radio.
C. Connect the Kicker® amplifi er body harness to the Mobile-Ease harness.
D. Connect the remaining connector of the Kicker® amplifi er body harness back to the factory wiring.
Kicker
mobile-ease
Factory Radio
Radio
module
Harness
ampli er
23. Connect the white two pin connector of the subwoofer harness to the corresponding connector on the
amplifi er harness.
24. Connect the black ground wire of the amplifi er harness and the subwoofer harness to the bolt in just
below the edge of the dash. Torque to 20Nm. Fig. 17
25. Install the amplifi er/bracket assembly over the HVAC blower housing stud and behind the bottom of the
glove compartment. Line up the holes in the bracket with the holes in the glove compartment and reinstall
the screws, leave loose. Fig. 18
26. Reinstall the nut and provided star washer on the blower housing stud and tighten, then tighten the
glove compartment screws.
5
Advertisement
