Download Print this page

Kicker PMUSP10 User Manual page 8

Designed for 2010–2011 ford mustang vehicles
Hide thumbs Also See for PMUSP10:

Advertisement

There is a problem with the multi-channel stereo amplifi er:
• Check the battery voltage to make sure it is not discharged below 11 volts.
• Check the negative battery cable to see if it has been securely tightened back on the battery.
• Check the inline fuse located near the battery to see if it is plugged in completely and not blown.
• Check the multi-pin connectors at the back of the radio and at the amplifi er chassis to make sure they
are plugged all the way in.
• Check the ground wire connection to make sure it is tightly secured to the proper ground in the vehicle.
Symptom
No Subwoofer Output
Radio Not Coming On
Radio Comes On, But No
Sound From Any Speakers
P.O. Box 459 • Stillwater, Oklahoma 74076 • USA • (405) 624–8510
8
Possible Cause
Fuse not installed in inline fuse
holder on subwoofer and / or amp
harness
Low battery voltage
Negative battery cable not
connected
Power wire connector not
connected to body harness
Ground wire not grounded properly
Balance or fader controls not set to
neutral position
No low frequency information in
music
Subwoofer harness not properly
/ completely connected to sub-
woofer.
Blown radio fuse
Low battery voltage
Fuse not installed in inline fuse
holder on amplifi er harness
Ground wire not grounded properly
Low battery voltage
stillwater designs
Solution
Install fuse into fuse holder.
Refer to instructions for correct
placement
Recharge the battery
Reconnect negative battery cable
Connect power wire to body
harness. Check for loose
connection
Check ground wire with voltmeter
to insure it is a good ground
Set balance and fader control to
center settings. (only effects stand
alone subwoofer kit)
Test with several different songs
Securely fasten both of the
connectors on the subwoofer
harness to the subwoofer. Check
for loose connections.
Refer to owner's manual for radio
fuse location and value
Recharge the battery
Install fuse into fuse holder. Refer
to instructions for correct place-
ment
Check ground wire with voltmeter
to insure it is a good ground
Recharge the battery

Advertisement

loading