Calls cannot be made from the terminal
connecting to external device such as car
navigation or handsfree device.
If calls are made several times when the
・
other party does not answer or is out of
service, the call to this number may be
disabled. In this case, turn terminal off and
on.
External device connection
■
An external device connected using USB
cable A to C etc. is not recognized.
Remove the external device and attach
・
again, then tap [Detect USB device]
P.159
→
However, some devices may not be
detected.
Map/GPS
■
Cannot set AUTO-GPS service
information.
Check if the battery level is low and AUTO-
・
GPS function stops.
If AUTO-GPS stops due to "Low-power
operation settings", AUTO-GPS service
information cannot be set. In this case, set
"Low-power operation settings" to "Not
suspend" or charge the battery.
P.180
Check if "AUTO-GPS operation settings" is
・
marked.
P.180
→
Error messages
No service
●
The terminal is out of service area, or the
・
received signal is too weak. Move to a
location where radio signal can be
reached.
The docomo nano UIM card is not
・
working properly.
Removing and inserting docomo nano
UIM card may solve the problem.
If the problem persists, try inserting the
docomo nano UIM card into another
u
[OK].
terminal. If this works, it is probably the
terminal that is causing the problem. In
this case, contact "Repairs (Inquiries/
Request)" on the last page of this manual
(in Japanese only).
Mobile network not available
●
Install docomo nano UIM card correctly
(P.31), then move to a location where radio
signal reaches.
Unknown error. Could not switch to video
●
call.
This appears when switching to video call is
not available. If the other party's phone is
P.34,
→
not compatible with video call or the other
party uses Call waiting, or during voice
guidance play, switching is not available.
214
Appendix/Index