Configuring A Mac Address Deny List - Cisco NCS 4200 Series Configuration Manual

Configuring MAC Address Security on Service Instances and EVC Port Channels
Command or Action
Step 13
end
Example:
Device(config-if-srv)# end

Configuring a MAC Address Deny List

Perform this task to configure a list of MAC addresses that are not allowed on a service instance that is a
member of a bridge domain.
SUMMARY STEPS
1. enable
2. configure terminal
3. interface type number
4. service instance id
5. encapsulation dot1q vlan-id
6. bridge-domain bridge-id
7. mac security address deny mac-address
8. mac security address deny mac-address
9. mac security address deny mac-address
10. mac security address deny mac-address
11. mac security address deny mac-address
12. mac security
13. end
DETAILED STEPS
Command or Action
Step 1
enable
Example:
Device> enable
Step 2 configure terminal
Example:
Device# configure terminal
Purpose
Returns to user EXEC mode.
ethernet
Purpose
Enables privileged EXEC mode.
Enters global configuration mode.
Layer 2 Configuration Guide for Cisco NCS 4200 Series
Configuring a MAC Address Deny List
• Enter your password if prompted.
49