Configuring A Mac Address Permit List - Cisco NCS 4200 Series Configuration Manual

Configuring MAC Address Security on Service Instances and EVC Port Channels

Configuring a MAC Address Permit List

Perform this task to configure permitted MAC addresses on a service instance that is a member of a bridge
domain.
SUMMARY STEPS
1. enable
2. configure terminal
3. interface type number
4. service instance id
5. encapsulation dot1q vlan-id
6. bridge-domain bridge-id
7. mac security address permit
8. mac security address permit
9. mac security address permit
10. mac security address permit
11. mac security address permit
12. mac security
13. end
DETAILED STEPS
Command or Action
Step 1
enable
Example:
Device> enable
Step 2 configure terminal
Example:
Device# configure terminal
Step 3
interface type number
Example:
Device(config)# interface gigabitethernet2/0/1
Step 4 service instance id
Example:
Device(config-if)# service instance 100 ethernet
ethernet
mac-address
mac-address
mac-address
mac-address
mac-address
ethernet
Configuring a MAC Address Permit List
Purpose
Enables privileged EXEC mode.
• Enter your password if prompted.
Enters global configuration mode.
Specifies the interface type and number, and enters
interface configuration mode.
Creates a service instance (an instance of an EVC) on an
interface and enters service instance configuration mode.
Layer 2 Configuration Guide for Cisco NCS 4200 Series
47