Verizon Wireless V620 User Manual page 28

Show wireless device battery instead of PC battery: If you only selected to detect and install Wi-Fi when installing
VZAccess Manager, VZAccess Manager will display the PC's battery status in its main window. If you are using a WWAN
device and this option is selected, the battery level of your WWAN device will be displayed when your device is connected
and detected by VZAccess Manager, as well as when you connect and disconnect using your WWAN device. Battery
Status cannot be updated while you are connected. You can refresh the status when you are not connected, by selecting
"Tools", "Refresh Signal Levels" from VZAccess Manager's main window. Some phones fail to accurately report their
battery level to VZAccess Manager and some WWAN devices such as PC Cards do not use batteries, so you can use this
option to display the PC's battery instead.
Set Options . . . : This is used to set various connect options. See below.
Automatically Connect: If desired, you can select to have VZAccess Manager automatically connect to Verizon Wireless
NationalAccess - BroadbandAccess or NationalAccess at application startup.
Show non-wireless accounts in list: If you select this option all of your dial up accounts will show up in VZAccess
Manager's list of accounts, allowing you to use VZAccess Manager to launch them instead of Dial-Up Networking. With
this option unchecked, the only connections that are displayed in VZAccess Manager's list of accounts, are the Verizon
Wireless NationalAccess - BroadbandAccess, NationalAccess or Quick 2 Net (14.4 kbps) connection, (depending on your
wireless phone/device capabilities) and any Wireless connections you have created, manually or with the Copy Accounts
Wizard. If VZAccess Manager is also configured for Wi-Fi, these connections will also be displayed when in coverage of
the hot spot.
Do not prompt for user name and password: If you are only using the Verizon Wireless NationalAccess -
BroadbandAccess, NationalAccess or Quick 2 Net (14.4 kbps) connection, this setting has no effect. If you created
Wireless connections to dial into other networks or have existing connections you are going to launch using VZAccess
Manager, checking this option will skip the screen that normally asks for your user name and password. For this to work
you will have had to connect previously, successfully saving your user name and password.
Security Setup...: This is used to lock/unlock the PC Card as well as change the lock code on the PC Card. This option
is only available for PC Cards.
28
Revision 7/7/05