Verizon Wireless V620 User Manual page 18

If your expected connection does not appear or if you connected your wireless phone and cable, or inserted your wireless
CDMA PC Card or Wi-Fi Card after starting VZAccess Manager, select "Refresh Networks" from the "Options" menu. This
will cause VZAccess Manager to look for your wireless device(s) and verify network availability. If you have any Wi-Fi
networks you manually added because they do not broadcast their SSID, they will always be displayed, and you will have
to refer to the signal strength displayed to know when you are in range. See the section "
additional details.
Note that with certain Wi-Fi adapters the signal strength for Wi-Fi networks is not accurate until you connect to
the network.
Note: The Quick 2 Net (14.4 kbps) connection is only created when the WWAN option is selected during setup and if
your wireless device supports it. The NationalAccess connection is only created when the WWAN option is selected during
setup and if you are using a NationalAccess capable device that does not support the Verizon Wireless BroadbandAccess
service. If you are using a BroadbandAccess capable device a NationalAccess - BroadbandAccess connection will be
created. This connection will use BroadbandAccess if available and will automatically attempt a NationalAccess connection
when BroadbandAccess is not available.
If you change phones or PC Cards, you will need to run the Setup Wizard again. To do this make sure that your
phone and cable are connected, then select "Run Wizard" from the "Options" menu.
Revision 7/7/05
Wi-Fi Specific Settings"
18
for