Appendix - VTech CS6114 User Manual

Appendix

Screen display messages
Cal l log empty
Copy from DIR..
Cal l log empty
Directory empty
Directory ful l
Ended X:XX:XX
Incoming cal l
Line in use
Low battery
New voicemail
No battery
No line
No signal
Not available
Number repeated
Out of range OR
no pwr at base
Phone X:XX:XX
Place in charger
Ringer muted
Ringer off
Saved
XX missed cal ls
XX new messages
** Paging **
There are no call log entries.
The telephone is loading entries from Directory for speed
dial assignment.
There are no call log entries.
There are no directory entries.
The directory is full.
You have just ended a call.
There is an incoming call.
A system handset or another telpehone on the same line
is in use.
The battery needs to be recharged.
There are new voicemail message(s) from the telephone
service provider.
No battery is installed. Follow the directions for battery
installation on page 4 to install the battery before charging.
There is no telephone line connected.
Communication between handset and telephone base is
lost during a call.
One handset is already viewing the call log or directory
and another handset attempts to review it.
The telephone number entered is already stored in the
directory.
The handset cannot communicate with the telephone
base. Check the telephone base power connection or
move closer.
The handset is on a call.
The battery is very low. Place the handset in the telephone
base or charger for recharging.
The handset ringer is muted temporarily during an
incoming call.
The handset ringer is turned off.
Your selection has been saved.
There are calls that have not been reviewed in the call log.
There are new messages in the answering system.
All system handsets are being paged.
31