Restrict Access To Switch Management - TRENDnet TEG-40080ES User Manual

TRENDnet User's Guide
Restrict access to switch management page
System > IP Access List
This section allows you to define or restrict access to the switch management page to a
list of specific IP addresses.
1. Log into your switch management page (see
on page 7).
2. Click on System, and click on IP Access List.
3. Review the settings.
First, enter the IPv4 or IPv6 address to allow access and click Apply to save entries into
the IP Access List. A maximum of 5 IP addresses can be added to the IP Access List.
For each entry, the access list will populate. You can remove IP addresses from the IP
Access List simply by deleting the entries and clicking Apply.
To limit access to your switch management page to a single user at a time, simply check
the Limit Single User Access box and click Apply. Access to the switch management
page will automatically timeout after 5 minutes.
4. Click Apply to save configuration changes to the NV-RAM to ensure that if the switch
is rebooted or power cycled, the configuration changes will still be applied.
© Copyright 2017 TRENDnet. All Rights Reserved.
"Access your switch management page"
Change administrator password and add accounts
System > Administration
This section explains how to change the administrator password create additional
administrative user accounts for access to the switch management page.
1. Log into your switch management page (see
on page 7).
2. Click on System, and click on Administration.
To change the administrator password, first enter the current password and then enter
and confirm the new password in the avaliable cells. Click Apply to save the new
password.
Note: The password consists of up to 12 alphanumeric characters.
4. Click Apply to save configuration changes to the NV-RAM to ensure that if the switch
is rebooted or power cycled, the configuration changes will still be applied.
TEG-40080ES
"Access your switch management page"
11