Bridge - TRENDnet TEG-40080ES User Manual

8-port 10g easy smart switch
Hide thumbs Also See for TEG-40080ES:
Table of Contents

Advertisement

TRENDnet User's Guide
Flow Ctrl: Flow Control, This parameter reflects the current flow control setting
on the port. The switch uses a special pause packet to notify the end node to
stop transmitting for a specified period of time. The possible values are:
o
Enabled - This parameter indicates that the port is permitted to use
flow control.
o
Disabled - This parameter indicates that the port is not permitted to
use flow control.
5. Click Apply to save configuration changes to the NV-RAM to ensure that if the switch
is rebooted or power cycled, the configuration changes will still be applied.
© Copyright 2017 TRENDnet. All Rights Reserved.

Bridge

Configure Trunking
Bridge > Trunk Config > Trunking
Important Note: Do not connect the cables of a port trunk to the ports on the switch
until you have configured the ports on both the switch and the end nodes. Connecting
the cables prior to configuring the ports can create loops in your network topology.
Loops can result in broadcast storms which can severely limited the effective bandwidth
of your network.
1. Log into your switch management page (see
on page 7).
2. Click on Bridge, click on Trunk Config, and click on Trunking.
3. Review the settings. For each trunk group, click Apply to save changes.
Distribution Criterion: This parameter indicates the criterion to balance traffic
between members of the Trunk Group. This allows the switch to specify criteria
to allow for the most efficient traffic distribution. The optimal choice will
depend on your network environment.
o
SA-This parameter indicates the switch is distributing traffic to links
within the trunk group based on the Source MAC address only.
o
DA- This parameter indicates the switch is distributing traffic to links
within the trunk group based on the Destination MAC address only.
o
SA + DA- This parameter indicates the switch is distributing traffic to
links within the trunk group based on the Source MAC address and
Destination MAC address.
TEG-40080ES
"Access your switch management
page"
13

Advertisement

Table of Contents
loading

Table of Contents