Radio Or Manual Control - HTC 950 RX Manual

Radio or manual control

The HTC 0 RX™ can be operated both via the built-in
control panel see picture  on the grinder and via the sepa-
rate radio control panel see picture 2.
When operating manually, it is the operator that moves the
grinder forwards across the floor without any drive from
the wheels. Check that the wheel locks are released when
operating manually.
See picture . page .
When the grinder is being run via the radio control unit, the
machine is propelled forwards and turned using the motors
that are positioned in the drive motor box (see pos. 2 page
12). In order for the motors to be able to drive the wheels,
the wheel locks must be protected between the wheels and
the drive motors.
See picture 2. page 19.
Standby
Turning the key on the grinder control panel to the right is
necessary in order to activate the grinder functions. When
the key is in this position the "Power lamp" lights on the
operator panel indicating that the grinder is in "Standby
mode".
Picture.1..Control.panel.on.the.machine..When.the.key.is.turned.
to. the. right,. the. "Power. lamp". indicates. that. the. grinder. is. in.
standby.mode.
Picture.2..Control.panel.on.the.radio.control.unit.
24