Change Of Radio Frequency - HTC 950 RX Manual

3. Turn the "Grinding head rpm" potentiometer (4) to MIN.
4. Set the "Grinding head Off/On" switch (5) to STOP.
5. Press "Off/On, Emergency stop" (1) to switch off the
hand controller.

Change of radio frequency

If more than one machine is to be used at the same work-
place, the radio transmitters may interfere with each other.
If this happens, the frequency of the machine may have to
be changed. If there is any other equipment that interferes
with the radio communication, the frequency may have to
be changed to prevent the machine stopping.
This is how to change the frequency of the machine with
the hand controller:
1. Stop the machine as described under "Stop routine
– radio control" (page 26).
2. Hold down the "Start radio communication" button (12).
3. Press the "Frequency" button (3).
4. Release the "Start radio communication" button (12).
5. Start the machine as described under "Start routine
– radio control" (page 26).
The receiver on the machine automatically finds the new
frequency.
On loss of radio contact
If the distance between the machine and the radio control
unit becomes too great, communication is cut off and the
machine stops. To resume operation via the radio control
unit, follow the procedure under "Start routine with radio
control".
27