HIKVISION 26 series Quick Start Manual page 34

Network Bullet Camera·Quick Start Guide
No.
1
2
3
4
5
6
7
Steps:
1) Feed the plugless network cable ⑦ through the lock nut ⑥,
waterproof rubber gasket ⑤ (the rubber gasket inset ridge
must face the waterproof endcap), and the waterproof endcap
④ in order.
2) Crimp an RJ-45 network plug ③onto the end of the cable,
taking care to insert the twisted pairs of wires in correct order.
3) Place the O-type gasket ② onto the end of the camera's
network interface socket ①.
4) Insert the network plug ③ into the camera's network interface
socket①.
Table 2-1 Components
Components
Camera's Network Interface Socket
O-Type Gasket
Network Plug
Waterproof Endcap
Waterproof Rubber Gasket
Lock Nut
Network Cable from Router/Switch
33