HIKVISION 26 series Quick Start Manual page 27

Network Bullet Camera·Quick Start Guide
3. If you need to route cables through the wall (or the ceiling), cut a
cable hole according to the drill template. Skip this step, if you
want to route the cables on the surface of the wall (or the ceiling).
4. Route the cables of the camera.
5. Secure the camera to the wall (or the ceiling) with expansion
screws.
Drill Template
6. Adjust the view angle.
3-axis (pan/tilt/rotation) adjusting allows adjustment for optimum
camera rotation and placement. Follow the steps below to adjust
the view angle.
Pan Adjustment
Steps:
Loosen the lock screw 1.
1).
Adjust the panning position of the camera. The adjusting range
2).
is from 0° to 360°.
Tighten the lock screw 1.
3).
Figure 2-12 Secure the Camera
26
Drill Template