Settings - Fujitsu fi-600F Operator's Manual

Chapter 2 How to Scan Documents
2.1 Scanning Documents
This section explains about the basic flow of performing a
scan.
In order to perform a scan, you need a scanner driver and an
image scanning application that supports the scanner driver.
The following scanner drivers and image scanning application
are bundled with the scanner:
 Scanner driver
- PaperStream IP (TWAIN)
- PaperStream IP (TWAIN x64)
- PaperStream IP (ISIS)
 Image scanning application
- PaperStream Capture
HINT
For details about the scanner drivers and the image scanning
application, refer to "1.6 Bundled Software" (page
Scanning procedures and operations slightly vary depending
on the image scanning application.
For details, refer to the image scanning application manual.
The following describes the normal procedure for scanning.
1
Turn on the scanner.
For details, refer to "1.3 Turning the Power ON/OFF" (page
2
Open the document cover.
For details, refer to "1.4 Opening/Closing the Document Cover" (page
18).
3
Place a document on the document bed.
Place the document face-down to align its top left-hand corner with
the reference point.
20).
4
Gently close the document cover.
For details, refer to
18).
17).
5
Start an image scanning application.
6
Select a scanner driver.
For some image scanning applications, selection of a scanner driver
may not be needed.
Reference Point
"1.4 Opening/Closing the Document Cover" (page
TOP
Contents
Index
Introduction
Scanner
Overview
How to Scan
Documents
How to Use the
Operator Panel
Various Ways to
Scan
ABC
Daily Care
Troubleshooting
Operational

Settings

Appendix
Glossary
25