Input Buttons - Sony STR-DH190 Operating Instructions Manual

Remote control
GB
10
  (power) (page 18)
Turns the receiver on or sets it to the
standby mode.
SLEEP
Sets the receiver to turn off
automatically at a specified time.
Each time you press this button, the
display changes cyclically as follows.
0-30-00  1-00-00  1-30-00 
2-00-00  OFF
When Sleep Timer is being used,
"SLEEP" indicator lights up on the
display panel.
Tip
• To check the remaining time before the
receiver turns off, press SLEEP. The
remaining time appears on the display
panel.
• The Sleep Timer will be canceled when you
perform the following.
– Press SLEEP again.
– Press  (power).
SPEAKERS A/B (page 19)
Switches the speaker system.
Each time you press this button, the
display changes cyclically as follows.
SPK A  SPK B  SPK A+B 
OFF SPEAKERS*
* "OFF" and "SPEAKERS" appears alternately
on the display panel.
Note
No sound is output from the speakers when
you select "OFF SPEAKERS". Be sure to select
setting other than "OFF SPEAKERS".

 Input buttons

BLUETOOTH, INPUT 1, INPUT 2,
INPUT 3, INPUT 4, PORTABLE IN,
PHONO, FM
Selects the input channel connected to
the device you want to use. When you
press any of the input buttons, the
receiver turns on.
Note
When you press BLUETOOTH, the receiver
turns on only if "BT POWER" is set to "BT ON"
(page 28).