Sony STR-DH190 Operating Instructions Manual page 28

• "BT POWER" (BLUETOOTH signal)
– "BT ON": You can connect to the
receiver from a paired BLUETOOTH
device.
– "BT OFF": The receiver cannot be
connected from a paired BLUETOOTH
device.
Note
You cannot change this setting when
"BLUETOOTH" input is selected.
 "PH.OFFSET" (Phono volume
offset)
Lets you adjust the volume level of the
device connected to PHONO IN jacks.
MM type cartridge used on turntable have
a variation of audio output level.
In case MM type cartridge output is small,
you can use phono volume offset to
increase the level.
You can adjust from 0 dB to +6 dB in
1 dB/step.
The initial setting is "PHONO 0".
 "BALANCE" (Speaker balance)
Lets you adjust the balance between left
and right speakers.
You can adjust from "BAL. L+10" to
"BAL. R+10" in 1 dB/step.
The initial setting is "BAL. 0".
 "NAME IN" (Naming inputs)
Lets you set the name of inputs and preset
stations. For details, see "Changing the
Name for Each Input and Preset Station
(NAME IN)" (page 29).
 "AUTO.STBY" (Auto standby)
Lets you set the receiver switch to standby
mode automatically when you do not
operate the receiver or when there is no
signals input to the receiver.
• "STBY ON"
Switches to standby mode after
approximately 20 minutes.
• "STBY OFF"
Does not switch to standby mode.
Note
• This function does not work when "FM TUNER"
input is selected.
GB
28
• If you use the Auto Standby mode and the Sleep
Timer at the same time, the Sleep Timer has
priority.
 "UPDATE" (Software update)
For service purpose only.
 "VERSION" (Software version)
Lets you check the system's software
version information.