Page 1
Fortin FTX44, FTX64, FTX75 with EVO Fortin FTX44, FTX64, FTX75 with EVO-ALL ***WARNING FTX5, FTX25 and ATX5 are not compatible with the EVO ***WARNING FTX5, FTX25 and ATX5 are not compatible with the EVO-ALL ***Only compatible with FMH 2 ***Only compatible with FMH 2-way Antennas 1.
Page 2
3. Plug in the Module you want to Flash update with the provided DATALINK cable. 4. Click on EVO-ALL OPTIONS tab. 5. Activate Supported RF Kits and option H2 – Fortin 2.
Page 3
6. Click SAVE OPTIONS. 7. Wait for the Options Saved message to appear in the top right corner. 8. Connect the FMH antenna and the EVO-ALL together with the cable adapter |# PART NO. : “RF-A2A”. StandAlone without T-Harness.
Page 4
StandAlone with T-Harness use the “Do-It-Yourself” way : Modify the Antenna cable supplied with the Fortin Antenna with a knife as shown. Attach a chassis Ground on Pin 3 and a 12V constant on Pin 4 of the supplied Antenna cable as shown.
Page 5
Insert the 4-Pin (Data-Link) connector. Release the programming button when the LEDs are BLUE AND RED. Press and hold the FORTIN programming button again for 5 seconds (Blue and Red will go Off and back On after 5 seconds). Turn ignition On, the Yellow LED will turn On.