gCreate gMax Printer 1.5+ Quick Start Manual page 5

C h o o s e a F i l e t o P r i n t
1. Slide the SD card (upside-down) into the left side of the LCD screen.
2. Using the LCD screen, the bottom line should now say "Card Inserted". If not, try removing the
SD card and reinserting it.
3. Push in the LCD screen knob (this is your accept button) and scroll down to "Print from SD" and
push in the knob again.
4. Select the file you wish to print and push the knob.
Y o u r f i r s t P r i n t
1. You will see the extruder move to the left until it hits the left (x-axis) endstop.
2. The bed will move forward until it hits the front (y-axis) endstop.
3. The extruder will go to the center of the bed and lower until the auto bed level sensor hits the
bed.
Because the auto bed level sensor the z-axis height must probe the
center of the bed. The printers actual "Home" position is in the left rear
of the print bed. Keep in mind when you click "Prepare > Auto Home"
from the menu this is not the actual home location.
Page 5