Nvram - DPS Telecom SCM G2 User Manual

13
6.5

NVRAM

Information entered through the terminal interface is stored in the Site Controller SCM's nonvolatile RAM.
Erasing or overwriting the nonvolatile RAM will alter the Site Controller SCM's configuration.
C)onfig > I)nitialize sets all configuration values to factory default settings. The I)nitialize command will erase
the stored NVRAM profile, removing the configuration file and all other configuration information. If you
choose the I)nitialize command, a confirmation prompt will ask you to confirm your choice — see Figure 6.12.
Note: Initializing the NVRAM will erase all configuration information. Do not initialize the NVRAM unless you
want to re-enter all configuration information.
6.6 Tune 202 Modem
Fig. 6.13. The A signifies that a modem tuning command has been acknowledged by the Site Controller SCM
It may be necessary to adjust the Site Controller SCM's internal modem to your network's requirements. To tune
the modem, choose C)onfig > T)une Modem.
You will see a menu as shown in Figure 6.13 above. After the menu, type a command. The modem is tuned using
the command characters described below in Table 6.A. When a valid command character is typed, the Site
Fig. 6.12. Set to factory default settings